Acorn 6210 water/condensation problem update 07.07.2012
I'm very happy and relieved to be able to say that the reason for the condensation problem in the Ltl Acorn 6210 Trail Camera has been identified.
After lengthy tests and analysis the cause of water getting into the control panel is, at long last, understood; and some final changes to the case upgrade are now being made.
I don't know exactly how long this will take, but it will be as fast as possible.
I will post a full explanation of the problem and how it was solved at a later date. Users of cameras which have this problem should remove the rubber bung (external power supply input) from the base of the camera.
...................................................................................................................................................................
The long awaited camera has arrived and is pictured on the left, following its first rudimentary water ingress test.
Change to the case design
This camera is rated IP54 which means limited dust ingress protection and protected against water spray from any direction. It is not rated as waterproof; as is no other camera of this type, as far as I'm aware.
To overcome an earlier problem with water getting into the control panel, located in the bottom door, the manufacturers have redesigned the case and door (see figures 3 and 4). These tests are to evaluate the effectiveness of the changes. I'm hoping to complete the tests in about four days.
First test results
During this first test the camera was subjected to a twenty litre shower and then left to stand for 30 minutes; after which it was dried off externally and opened up to check for any water inside.
I'm very happy and relieved to be able to say that the reason for the condensation problem in the Ltl Acorn 6210 Trail Camera has been identified.
After lengthy tests and analysis the cause of water getting into the control panel is, at long last, understood; and some final changes to the case upgrade are now being made.
I don't know exactly how long this will take, but it will be as fast as possible.
I will post a full explanation of the problem and how it was solved at a later date. Users of cameras which have this problem should remove the rubber bung (external power supply input) from the base of the camera.
...................................................................................................................................................................
 |
| Fig 1: The new, modified Acorn 6210 (MMX version) Dripping wet after its first water ingress test. |
Change to the case design
This camera is rated IP54 which means limited dust ingress protection and protected against water spray from any direction. It is not rated as waterproof; as is no other camera of this type, as far as I'm aware.
To overcome an earlier problem with water getting into the control panel, located in the bottom door, the manufacturers have redesigned the case and door (see figures 3 and 4). These tests are to evaluate the effectiveness of the changes. I'm hoping to complete the tests in about four days.
First test results
During this first test the camera was subjected to a twenty litre shower and then left to stand for 30 minutes; after which it was dried off externally and opened up to check for any water inside.
